SESSION 1A

AUTOMOTIVE SPRAYS
(Room: Lakeshore East)

SESSION 1B

SPRAY MODELING
(Room: Lakeshore West)

Chairpersons: Scott E. Parrish, General Motors R&D, and Chia-fon Lee, University of Illinois at Urbana-Champaign

Chairpersons: Josette Bellan, Jet Propulsion Laboratory and California Institute of Technology, and Rolf D., Reitz, University of Wisconsin-Madison

9:00 am

Multi-Hole Injector Spray Characterization Utilizing White Light Volume Illumination and Schlieren Techniques
Adam Pawlowski, Aachen Reinhold Kneer, RWTH Aachen and Scott E. Parrish, General Motors R&D

Modeling requirements for Large Eddy Simulation of multicomponent fuel two-phase flows using Continuous Thermodynamics
Josette Bellan and Laurent Selle, Jet Propulsion Laboratory and California Institute of Technology

9:25 am

Experimental and Numerical Investigation of Common-Rail Ethanol Sprays at Diesel Engine-Like Conditions
Peter Spiekermann, Sven Jerzembeck, Stefan Vogel, Christian Felsch, Norbert Peters from RWTH Aachen, Germany

A Continuous Thermodynamics Formulation for the Vaporization of Liquid Mixtures
Way Lee Cheng, Chia-fon Lee, University of Illinois at Urbana-Champaign

9:50 am

Fuel film measurements of an impinging Diesel spray
Ben Steinhaus, Jaal Ghandhi, University of Wisconsin-Madison

A New Spray Model for Transient Diesel Sprays with Time-varying Injection Rates
Neerav Abani, Rolf D., Reitz, University of Wisconsin-Madison

SESSION 2A

ATOMIZATION
(Room: Lakeshore East)

SESSION 2B

Panel Session
DENSE SPRAY DIAGNOSTICS
(Room: Lakeshore West)

Chairpersons:Douglas G. Talley,
Air Force Research Laboratory, and Stephen D. Heister, Purdue University

Moderator:  Greg Smallwood, NRC Canada

10:30 am

This session was organized by the Measurement and Instrumentation Technical Committee.  A one page “mini-paper” that provides some details regarding the methods discussed is included in the book of abstracts.

Yudaya Sivathanu, En’Urga
Visible Light Extinction Tomography

Terry Parker, Colorado School of Mines 
Infrared Scattering

Jin Wang, Argonne National Laboratory
X-Ray Extinction

Mark Linne, Sandia National Laboratory
Ballistic Imaging

Moderated Discussion
Panelists and Audience

On the Contribution of Orifice Design to the Primary Atomization Process
James V. Canino, Stephen D. Heister, Purdue University

10:55 am

The primary breakup of a round liquid jet by a coaxial flow of gas
Dokyun Kim, Olivier Desjardins, Marcus Herrmann, Parviz Moin, Stanford University

11:20 am

A Method to Predict Atomization Performance in Gas-Centered
Swirl-Coaxial Injectors
Malissa D.A. Lightfoot, Stephen A. Danczyk, Douglas G. Talley, Air Force Research Laboratory

11:45 am

Low pressure atomization and mixing to simulate cryogenic fluid behavior in a thermodynamic vent system for long storage duration
Philippe Konieczny, Jean-Paul Thibault, Bruno Vieille, CNES, France

SESSION 3A

ELECTROSTATICS
(Room: Lakeshore East)

SESSION 3B

 DROPLET DEFORMATION AND BREAKUP
(Room: Lakeshore West)

Chairpersons: Farzad Mashayek, University of Illinois at Chicago, and Dimitrios Kyritsis, University of Illinois at Urbana-Champaign

Chairpersons: Chia-fon Lee, University of Illinois at Urbana-Champaign, and Nasser Ashgriz, University of Toronto

1:30 pm

Electrostatic Atomization of Vegetable Oils
G. Al-Ahmed, University of Illinois at Chicago, J. S. Shrimpton, Imperial College, London, and F. Mashayek, University of Illinois at Chicago

A model for deformation of liquid jets and droplets subjected to gaseous flows
Alireza Mashayek, University of California San Diego Ali Jafari and Nasser Ashgriz, University of Toronto

1:55 pm

Electrostatically Assisted Fuel Injection and Charged Droplet Combustion
Eric Anderson, University of Illinois at Urbana-Champaign Antonio, P. Carlucci and Arturo De Risi, University of Lecce, Italy and Dimitrios Kyritsis, University of Illinois at Urbana-Champaign

Modeling Droplet Breakup Processes in Biodiesel Engines under Micro-Explosion Conditions
Kuo-Ting Wang, Chia-fon Lee, University of Illinois at Urbana-Champaign

2:20 pm

POSTER SESSION

SESSION 4A

DIAGNOSTICS
(Room: Lakeshore East)

SESSION 4B 

COMPUTATIONAL METHODS
(Room: Lakeshore West)

Chairpersons: James A. Drallmeier, University of Missouri – Rolla, and Mark Linne, Sandia National Lab

Chairpersons: Chris Edwards, Stanford University, and M.F. Trujillo, Penn State University

3:25 pm

Propagation of ultra-short laser light pulses in spray environments
Edouard Berrocal, Combustion Physics Lund University  David L. Sedarsky, Megan E. Paciaroni, Igor V. Meglinski, Mark A. Linne, Sandia National Lab

Beyond the Point Particle: LES-Style Filtering of Finite-Sized Particles.
Brooks Moses, Chris Edwards, Stanford University

3:50 pm

Development of a Non-intrusive Film Thickness Measurement Technique for Dynamic Shear-driven Thin Liquid Films
Mark A. Friedrich, Hai Lan, James A. Drallmeier, and Bassem F. Armaly, University of Missouri – Rolla

Accurate Spray Simulations using the Lagrangian-Eulerian Method
Rahul Garg, Shankar Subramaniam, Iowa State University

4:15 pm

Ballistic imaging of the near field for jets in gaseous crossflow
David Sedarsky, Lund University Megan Paciaroni, International Scientific Solutions Incorporated

Analytical Calculations of Spatial Accuracy of Collision Rate Computations
Scott Post, Bradley University,
Foo-Chern Ting, Ford Motor Co., and Song-Lin Yang, Michigan Technological University